Frequently
Asked Questions
1.
What is the difference between the Pro Mod and
the Quickrod?
The PM and the QR are the same amp the only
difference is the KT88's in the PM and EL34's in the QR.
2.
What is the tonal difference between the Pro Mod
and the Quickrod?
The
PM has more of a modern tone, bigger and tighter lowend, less
midrange and more aggressive on the top end. The QR has the classic
80's vibe with dynamic midrange with a smooth top end.
3.
Is the Quickrod only good for 80's and VH tones?
The
QR only sounds like VH if you can play like VH. It has the classic
EL34 mids that gives it that title, however it can do heavier
stuff with ease.
4.
What is the Mode Switch?
The Mode switch is a 3 position rotary switch that only effects
the overdrive channel. The 1st position which is called 1st gear
has the modded Plexi tone, less lowend and gain with a little
more top end. 2nd gear is a bolder tone more lowend and gain and
a little less top end. 3rd gear is the same as 2nd with more gain
added in.
5.
Is the Effects loop series or parallel?
The
loop is series and it is a ss design. The loop will seem to add
gain and high end to the tone, however as you bring the master
volume up the power section catches up with the pre-amp section.
6.
Does the Effects loop alter my tone?
Anytime
you put something in the signal path it will effect the tone.
Most processors have gain settings to help compensate this. If
you are concerned with a piece of gear dramatically affecting
your tone, you can check the loop by engaging it without anything
connected. If the loop adds a little boost and does not alter
the tone dramatically then you need to check the settings of your
outboard gear.
7.
What does the half power switch do?
The half power switch disconnects the the two outside power tubes.
You will need to set your ohm selector on the amp to half of what
you speaker cab ohm load is.
8.
Can I get a PM headbox if I order a QR?
Yes you can get any headbox with any amp. Some options like the
maple panels and graphics are an upcharge.
9.
Do you offer a trial period?
No we do not offer a trial period because we consider each amp
a special order. Some of our dealers offer this, so you can check
with them before placing the order.
10.
Do your amps have a voltage selector?
Yes we install a selector that will run at 100-120-220-240 volts.
11.
Can I use an external switching system?
Yes any switching system that uses latching relays will work.
You will need a total of three relays to control all of the functions.
The layout of the two 1/4" jacks on the amp are Footswitch
jack A tip is for the solo boost function, the ring is for the
OD1/OD2 function, Footswitch B tip is for the clean/overdrive
function.
11.
Can I get replacement front panels and control
panels for my amp.
Unfortunally
we had to stop offering this due to our back log, we still offer
replacement headboxes.
For
product information or general
questions please email us
scott@splawnguitars.com
Sometimes emails do not get to
us so if
you do not hear back from us please call
704.922.0020
Please email webmaster@splawnamps.com
concerning problems, suggestions,
or information about this site Copyright © 2004 Splawn Amps
